Neumann KM 185 Stereo Set

Neumann KM 185 Stereo Set

2 * KM 185
2 * WNS 100 Windscreen
2 * SG 21 Stativeadapter

KM 185

The KM 185 with its hypercardioid characteristic features attenuation of sound incidence from the side or rear of about 10 dB, with minimum sensitivity at an angle of 120°.

Features:
Successor of the worldwide successful KM 83/84
Transformerless circuitry

Technical Specifications:
Acoustical operating principle     Pressure/Pressure gradient transducer
Directional pattern     omnidirectional/cardioid/hypercardioid
Frequency range     20 Hz ... 20 kHz
Sensitivity at 1 kHz into 1 kohm   10 mV
Rated impedance     50 ohms
Rated load impedance     1 kohms
Equivalent noise level, CCIR1)    24 dB
Equivalent noise level, A-weighted1)    15 dB-A
Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL)    70 dB
Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL)     79 dB
Maximum SPL for THD 0.5%2)    142 dB
Maximum output voltage     10 dBu
Supply voltage (P48, IEC 61938)     48 V ± 4 V
Current consumption (P48, IEC 61938)     3.2 mA
Matching connectors     XLR 3F
Weight     approx. 80 g
Diameter     22 mm
Length     107 mm

WNS 110
Close range sounds, wind, and fast movements of the microphone boom, all may cause interfering noises. To avoid these unwanted sounds, windscreen accessories are available. Typically, they are made out of open-cell polyurethane foam. These windscreens do not cause interfering resonances and do not influence the directional pattern. Only in the upper frequency range is the output level slightly attenuated. The wind noise attenuation was measured without electrical filtering in a turbulent air stream traveling at 20 km/h, generated by a noiseless wind machine.
Acoustically transparent wind and pop protection with improved efficiency.
Wind noise attenuation 21 dB. Attenuation at 15 kHz 1 dB. Ø 45 mm, length 70 mm. Color black.

SG 21
Swivel mount with a plastic clamp for miniature microphones. It has a 5/8"-27 female thread, plus a thread adapter to connect to 1/2"- and 3/8" stands.